Skip to main content

Building the Enclosure

In order to build the enclosure, first modify the upper table as decribed below and then follow the Ikea Lack case instructions from prusa directly as there are no further changes needed.

Steps

  1. Cut the attached layouts from the table (table_top.dxf from the top side, table_bottom.dxf from tbe bottom side). You can put the table directly into a laser cutter for this.

  2. You need to cut all other layouts out of 4 mm plywood and glue it together as a box.

  3. Glue the box into the table like this:

  1. Follow Prusa's IKEA Lack case instructions to finish your enclosure. The air filter is just inserted into the hole to get the finished case: prusa_enclosure.jpg